Setting Of Date And Time - Pentax R-2501NS Instruction Manual

4. Selection of Stop bits: [STOP BITS]
Select the number of stop bits to be used: 1 or 2.
5. Selection of Control signal: [SIGNAL CONTROL]
Select whether the control signal is effective or not.
6. Selection of XON/XOFF: [XON/XOFF]
Select whether to enable or disable XON/XOFF.
7. Selection of Through command
: [THROUGH COMMAND]
Select whether to disable data output
without receiving any data request command
or enable the "a" to "f" command data output.

8.12 Setting of date and time

1. Input of date
Set date using [numeric keys].
Year / month / date
2. Input of time
Set time using [numeric keys].
Time : minute : second
• The date clock is powered by the built-in lithium battery. The lithium battery needs to be
replaced in five years. When the message "Li-batt.voltage s low." is shown on the display
screen, have the lithium battery replaced by the dealer from whom the instrument was
purchased. The timing of battery replacement varies depending on the frequency of use and
the environment where the instrument is stored while not in use.
X1.1 XaXXXXXX
2.2
X1.ON XaXXXXXX
2.OFF
X1.ON XaXXXXXX
2.OFF
X1.NILXXXXXXXXXX
2.a
3.b
4.c
5.d
6.e
7.f
08/12/24
00:00:01
47