Sequence Set; Setting Up A Salvo With A Sequence Set; Disabling The Configuration And Setup Menus On The Control Panel - GRASS VALLEY L-S series Instruction Manual

Sequence Set

Setting Up a Salvo with a Sequence Set

Disabling the Configuration and Setup Menus on the Control Panel

JUPITER L-S and LCD Series Control Panel Instruction Manual
A control panel's
sequence (salvo)
execute pre-built Jupiter sequences, where a sequence is a list of switches,
which switches one or more Sources to one or more Destinations.
A Jupiter sequence is built using the Jupiter Sequence Set table, an example
of which is shown in Figure
Figure 27. Sequence Set Table
Sequence Set - SETUP
Sequence
1 SETUP1
SETUP1
2
3 SETUP1
SETUP2
4
5 SETUP2
SETUP2
6
The sequence set is given an eight-character (max) name and is of type
"CP3800."
In this example, sequence set "SETUP" contain two sequences: "SETUP1"
and "SETUP2." "SETUP1" will switch Cameras 1 through 3 to Monitors 1
through 3 with a single Take command. If the Sources and Destination are
valid for all the levels marked yes, then the actual number of switches will
be 3 times the number of levels (3 events x 4 levels = 12 switches).
"SETUP2" will switch the cameras to VTRs 1 through 3. Each sequence can
use 100 event sequences as of Jupiter 7.8.1 (table rows).
The sequence set must be assigned to the panel on the Jupiter MPK Devices
table.
For additional information regarding Jupiter sequences and assigning
them to control panels, refer to the Jupiter CM-4000 Installation and Oper-
ating Manual.
Note Sequences are executed in slightly different ways, depending on the buttons
available on each panel type. Refer to the specific instructions for each panel.
You can disable the Configuration and Setup menus on the Control panel.
Some of the locked-out settings will still be accessible from the Control
Panels Web page; such as the ability to change the Device ID or the Connec-
button or menu setting can be used to
27.
Logical Logical
Input Output
CAM1 MON1
CAM2 MON2
CAM3 MON3
CAM1 VTR1
CAM2 VTR2
CAM3 VTR3
Control Panel Sets
Levels
YYYY
YYYY
YYYY
YYYY
YYYY
YYYY
63