Initial Atp-2000 Panel Device Configuration; Introduction; Ip Address Assignment; Panel Id Assignment - GRASS VALLEY ATP-2000 User Manual

Getting Started

Initial ATP-2000 Panel Device Configuration

Initial ATP-2000 Panel Device Configuration

Introduction

Configuring the ATP-2000 panel device is done from its control screen (web page). The IP
address of the unit is shown on the splash screen at power on. (See

IP Address Assignment

The ATP-2000 panel ships with DHCP enabled in its network settings. If a static IP address is
required, then this can be set up from the unit's control screen (web page) along with other
network interface settings. (See
connected to a network with a DHCP service enabled, then a suitable IP address is
automatically assigned to the unit at power on.

Panel ID Assignment

The ATP-2000 panel ships with no Panel ID set. This means that the panel will be presented
in the Network window of GV Orbit Client in the discovered devices section, without a
Panel ID yet being set.
A unique Panel ID must be set. (See

Panel Discovery

GV Orbit Client can automatically discover the panel (and its IP address) if the panel is
connected to a network with DHCP enabled and with multicast data packets enabled as
part of a GV Orbit system; the panel is presented in the Client's Network window. If the
panel's Panel ID has not yet been set up, then the ATP-2000 appears in the 'unassigned
devices' section of the Network window.
The control screen of the ATP-2000 panel can be opened from GV Orbit Client via the
Network window (right-click on the panel item and select 'Control').

Device List

In a GV Orbit system, the ATP-2000 automatically advertises its presence to the GV Orbit
server(s), and it receives a list of devices that it may control and it populates its Home
screen, listing the devices etc.
16
Step 1: Network
Note: The Panel ID takes the form of a RollCall address which must be
unique in a GV Orbit system.
Note: An ATP-2000 panel is discoverable, if multicast network traffic is
enabled and is visible to the Client and to the panel. See ATP-2000
Software Release Notes for IP port information. (See
Documentation, on page iii.)
Note: A web browser can be used to see the ATP-2000 panel's control screen
(web page), by entering the panel's IP address into the browser.
Settings, on page 18.) If the panel is
Step 2: GV Orbit Server Settings, on page 18.)
Figure 3-1 on page 14.)
Related