Operation Time Counter; Power Management; Geofence; Table 33: Output Functions - Danfoss TFX Installation And Operation Manual

OUTPUT FUNCTION
Make the settings for the input function under IO
C > D O
ONFIGURATION IGITAL UTPUT
1. Select the object D
IGITAL
2. In the C C
HANNEL ONFIGURATION
con guration ON – OFF
3. Save the changes.
The following variables are available:

Table 33: Output functions

Variable
C C
HANNEL ONFIGURATION
B D S
EHAVIOR ON EVI C E OFTWARE
S C
TATUS HANGE

5.6.3 Operation time counter

The device features an internal operation time counter.
The O object belongs to the object
PERATION TIME TOTAL
dictionary group D V
EVI CE ARIA B LES
The operation time counter cannot be reset. The operation
time counter runs as soon as the device is in standard
mode (not sleep mode).
For detailed information on creating objects, see chapter
Creating object dictionary groups and objects.

5.6.4 Power management

The device supports the following power modes:
> Standard mode
> Sleep mode (energy saving mode)
NOTICE
The device can only switch to sleep mode when terminal 15
is disabled (LOW).
In sleep mode, none of the device functions are available.
The required variables belong to the object dictionary group
D V > P M
EVI CE ARIA B LES OWER
M
ODULE
– C 6.
HANNEL
O – C 6.
UTPUT HANNEL
list, select the
D O .
IGITAL UTPUT
Function
Enable and disable the digital output.
Behavior on CANopen mode STOP
or . The output can
PREOPERATIONAL
retain its current value or be set to a
de ned value.
> I/O, S , D
ENSORS IAGNOSIS
.
ANAGEMENT
TFX INSTALLATION AND OPERATION MANUAL
You can enable sleep mode as follows.
> Enabling sleep mode after a set time period:
M
P
OWER ANAGEMENT
> Monitoring terminal 15. As soon as the device registers
LOW on terminal 15, a delay time is enabled. If timeout is
reached before the device detects HIGH on terminal 15,
the device goes into sleep mode:
P M
OWER ANAGEMENT
If the device detects HIGH on terminal 15 or a CAN message
while in sleep mode, it switches to standard mode (wake-up).
The device can only be woken from sleep mode into
standard mode by CAN1 messages. CAN2 messages are
not available with the current product o ering
You can con gure additional ags that switch the device to
standard mode.
> Wake-up after a de ned time:
P M
OWER ANAGEMENT
> Wake-up due to vibration. You can set the intensity of
the vibration:
P M
OWER ANAGEMENT
For detailed information on creating objects, see chapter
Creating object dictionary groups and objects.

5.6.5 Geofence

GEOFENCE MODE
The device features a geofence monitoring function. This
allows you to monitor whether the device is located inside
or outside a pre-de ned fence and when the device crosses
the fence.
.
There are three ways to de ne the fence:
> De ne center and radius of a circle. The center of the
circle is de ned as a xed point.
> De ne center and radius of a circle. The current position
on enabling the function is used as the center of
the circle.
> Two opposite points are de ned for a rectangle.
The variables belong to the object dictionary group
V > I
ARIA B LES NTERNAL
6046279-001
– C S T
AN LEEP IME
- S D T
HUT DOWN ELAY IME
NOTICE
- C W -U T
YCLI C AKE P IME
- A S W
CC ELERATION ENSOR
G .
EOFEN CE
March 2020
Operation
- F
AKE UP OR CE
D
EVI CE
33