Cables; Start Cable For Main Plug Connector; Table 12: Led Operating Modes, Status Indications, And Their Meaning - Danfoss TFX Installation And Operation Manual

Functionality and features
Example: The device does not recognize any GNSS position
(priority 4 = magenta) and has no mobile radio connection
(priority 1 = blue). The STATUS LED lights up blue.
LEDS DURING CERTAIN OPERATING MODES
The LEDs indicate certain active operating modes
and processes.
INFORMATION
The LED statuses shown in the table are examples.
The illumination of the LEDs can deviate from this
depending on the use purpose and conditions.
Table 12: LED operating modes, status indications, and
their meaning
LED Status
ON STATUS
ON STATUS
ON STATUS
ON STATUS
ON STATUS
ON STATUS
ON STATUS
ON STATUS

3.4 Cables

3.4.1 Start cable for main plug connector

The cable CLM3 start cable 6 open, 2 dsub ,1 pw, 2 m
(contained within the Starter Kit) features the following
connectors and open individual wires:
> 1 micro timer II socket,14-pin, female
> 2 D-sub, 9-pin, female (CAN1)
> 1 power connector
10
TFX INSTALLATION AND OPERATION MANUAL
Meaning
Con guration update
in progress via the
CAN interface.
Device is in Logging mode,
receives con gured CAN
messages (orange ash)
and transmits the logged
messages to the Data
platform (blue ash).
Active data transmission in
real-time mode.
Device initializing after
switching on.
Con guration update in
progress via the Data
platform.
Remote rmware update
in progress via the Data
platform.
Device reset via slide switch
on the D-sub port (CAN1).
Transmission of the GPS
position and the keep-alive
message. Display varies
depending on con gured
polling interval.
Micro timer II socket (14-pin, female)
Pin Designation
1 Terminal 30 / VCC
2 Factory setting 1
3 Terminal 31 / ground Green
4 Analog input 1
5 Analog input 2
6 Analog input 3
7 Digital output
8 Terminal 15
9 Factory setting 2
10 CAN2-GND
11 CAN2-High
12 CAN2-Low
13 CAN1-High
14 CAN1-Low
Start cable for main plug connector
INFORMATION
The open end connectors are numbered on the strand ends.
CAN2 not available with the current product o ering.
The polarity also applies for the following cable:
CLM3 start cable 6 open, 2 dsub, 1 pw, 2 m (contained
•
within the Starter Kit)
Individual open end wires
Designation Color
Terminal 31 / ground Green
Analog input 1 Yellow
Analog input 2 Gray
Analog input 3 Pink
Digital output Blue
Terminal 15 Red
Start cable for main plug connector, individual wires open
6046279-001 March 2020
Color Description
Power supply
(permanent positive
White plus vehicle battery)
Brown Input
Power supply
Yellow I/O input
Gray I/O input
Pink I/O input
Blue I/O output
Red Input (ignition signal)
Black Input
Violet -
Gray-pink CAN, bidirectional
Red-blue CAN, bidirectional
White-green CAN, bidirectional
Brown-green CAN, bidirectional
Description
Power supply
I/O input
I/O input
I/O input
I/O output
Input (ignition signal)