Table 22: Logging In Pgn 61444 - Conditions; Table 23: Logging In Pgn 61444 - Payload; Table 24: Mapping In Pgn 61444 - Active Condition; Table 25: Mapping In Pgn 61444 - Data Link - Danfoss TFX Installation And Operation Manual

Operation

Table 22: Logging in PGN 61444 - Conditions

Description Selection
L OR
OG MESSAGE ON
Use a xed value
L P (600000)
OGGING ERIO D
C / A
ON DITION LWAYS
not set
TRUE
C V volatile U8 index
OMPARISON ALUE
N
UM B ER OF B ITS
8
C ONTAINING DATA
A
C TIVE IF C OMPARISON
<>0
VALUE
Level triggered - This
operation will be carried
out each time the
T C condition is true.
RIGGER ON DITION
PAYLOAD
10. Select the P tab.
AYLOA D
11. Set and save the following:

Table 23: Logging in PGN 61444 - Payload

Description Selection
L
OG RE C EIVE D
C AN Set
MESSAGE
B 2 ... 5 and 8
YTES TO LOG
5.2.3.3.1 Mapping
During mapping, data is copied from the CAN message
to variables. You can then process the copied data in the
device and perform calculations.
26
TFX INSTALLATION AND OPERATION MANUAL
Function
The data is logged when
timeout is reached OR
the condition is met.
Duration of the logging
interval in milliseconds.
The data is logged
depending on the result
of the check.
Logging depends on the
U8 T
VOLATILE RIGGER
variable.
All 8 bits of the variable
are compared with
.
C OMPARISON VALUE
Data is only logged if
the variable
VOLATILE
U8 T is not equal
RIGGER
to 0.
Logging is enabled as
long as the variable
U8 T
VOLATILE RIGGER
not equal to 0.
Function
Log data of the receive CAN message.
Logging selected data bytes
MAPPING - ACTIVE CONDITION
1. Select the M
APPING
2. Select the A
CTIVE
3. Make the following changes:
is
Table 24: Mapping in PGN 61444 – Active Condition
Description Selection
A Set
LWAYS A C TIVE
DATA LINK
4. Select the D
ATA LINK
5. Make the following changes:
Table 25: Mapping in PGN 61444 – Data link
Description
P
ARAMETER
D
ATA START B IT WITHIN
RE C EIVE MESSAGE
N
UM B ER OF B ITS
C ONTAINING DATA
6. Click on the N
EW
The mapping entry is adopted in the table.
The data is copied into the internal variable on
reception of a CAN message.
6046279-001 March 2020
tab.
C tab.
ON DITION
Function
Mapping always takes place
without conditions.
tab.
Selection Function
The data is written to the
volatile S32 S 32 E
VOLATILE
engine speed new S variable.
PEE D NEW
The data used starts with bit
24 bits 24 (from byte 4).
The data used has 16 bits
16 bits (2 bytes).
button to create the mapping entry.
NGINE