Toshiba e-STUDIO5540C Service Manual page 1020

Sub
05/08 Mode Element
element
08 Setting Printer Feeding Bypass feed paper
Mode system / size detection setting
Paper
transport
08 Setting Printer Feeding
Mode system /
Paper
transport
08 Setting Printer All clearing Destination
Mode
e-STUDIO5560C/6560C/6570C (Ver08)
Sub-
Item Subitem Code
code
4621
4622
4659
Default Acceptable
Details
value value
With EFI 1 0-1
Bypass paper size 0 0-65535
detection counter
Storing area for SYS Refer to 0-255
destination contents
information
84
RAM Contents
M Detects whether the size of the paper fed by bypass
feeding is the same as that set on the control panel. If
the sizes are not the same, a warning message is
displayed (no paper jam occurs).
If the bypass paper size detection is not working, the
equipment can be used without any size detection by
disabling this setting. After repair, re-enable this setting.
0: Enabled
1: Disabled
M This is a counter for bypass paper size detection
setting. If the printing is executed with the paper size
that differs from the paper size set on the control panel,
the counter is counted up.
M Stores SYS-SRAM destination data when code 08-9090
is performed.
0: MJD/MJC
1: NAD/NAC
2: JPC
3: AUD/AUC
4: CND
5: KRD
6: TWD
7: SAD
8: ASU
9: ASD
10: ARD
<Default value>
MJD/MJC: 0
NAD/NAC: 1
JPC: 2
ASD: 9
AUD: 3
CND: 4
ARD: 10
Proce Servic
dure e UI
1
1
2