Furuno FAR-2107 Series Service Manual page 481

Hide thumbs Also See for FAR-2107 Series:

7.5.3 List of monitor units

The table below shows color LCD monitors connectable with FAR-2xx7 series.

Picture size

Set S1-#1/2 of the SPU board to OFF/ON. In this setting;

- Brilliance control signals included in DVI signals are not outputted.

- The [BRILL] icon bar is not displayed at the lower left of the screen.

When connection with FAR is made by RGB analog signals, the connection should be

made by way of DVI I/F and RGB BUFF boards offered as option. See the

Installation Manual of FAR radar for the method of connection.

For connection with the DVI-D connector, make connection directly. RCA signals are

not supported.

Due to difference in monitor resolution, signals are omitted and this makes characters

Electrically connectable

- Mini D-SUB15 pin

Table 7.5.2 Connection of LCD monitor

Note-1, Note-2

Note-3, Note-4

7.5 Monitor Unit

- RGB analog