Furuno FAR-2107 Series Service Manual page 218

OFF>00:15>0030>01:00> -- >
TRAIL MODE
30:00>CONT
VRM 1, 2 VRM ON/OFF
CU/TM RESET
ALARM ACK
HDG
SPD
OS POSN
RFE POINT ANT POSN>CONN POSN
ARPA OFF/ON
ARPA
(ON: MANU, AUTO MANU)
AIS AIS DISPLAY ON/OFF
AIS MSG Arrival
VECTOR TRUE>
VECTOR 30 SEC>1 MIN>2 MIN>
3 MIN>6 MIN>12 MIN>
15 MIN>30 MIN
OFF>30 SEC>1 MIN>2 MIN>
PAST POSN
3 MIN>6 MIN>
CPA LIMIT CPA ON/OFF
0.5 NM> ---- > 20 NM
CPA (0.5 – 10 NM/0.5 NM,
10 – 20 NM/1 NM step)
1MIN> --- > 60 MIN
TCPA LIMIT
(1 min step)
Guidance [ xxx / xxx ]
VECTOR REL
Can be set for each 30 seconds.
When this function is turned on, the
VRM is displayed.
While CU is active, CU is reset by
clicking the lift button. While TM is
active, TM is reset by clicking the lift
button.
Alarm acknowledge; silence the audible
alarm
[HDG] box menu is displayed.
[SPD] box menu is displayed
[OS POSN] box menu is displayed
On the bases of the radar ANT position
or conning position; changes the origin
point of range ring and cursor data.
Note:
Position entered in the [Menu] -> 0 -> 5.
Note:
[ARPA] Menu,
[Menu] -> 4, [Menu] -> 0 -> 6
[Menu] -> 0 -> 8 -> 4
Turns on and off AIS target display.
When [Menu] ->
FUNCTION setting is turned off, this
box display is erased.
Note:
[Menu] -> 4 -> 6, 7, 8, 9
Incoming AIS message, an envelope
mark is displayed when "3. AUTO DISP
MSG" setting in the [AIS] box menu is
turned on.
Sets the vector mode and vector time of
the ARPA and AIS.
Sets the interval of past position plotting
time of the ARPA and AIS target.
Note:
[Menu] -> 4 -> 5-> 4, 5
[Menu] -> 4 -> 6-> 5, 6
When clicking [CPT LIMT] box icon,
[CPA] and [TCPA] boxes are added.
Note:
[Menu] -> 3 -> 6 to 9
Note:
[Menu] -> 3 -> 6 to 9
The guidance box corresponds to the
right and lift click operation.
3-8
3.2 Box Menu
4 -> 8: AIS
YES
YES
YES
YES
YES
YES