Furuno FAR-2107 Series Service Manual page 19

How to change DVI I/F board
To replace DVI I/F board;
1. Place the monitor face down on a soft flat surface.
2. Remove 28 screws from the back of the monitor.
3. Unplug CN10, CN14, and CN16 and remove five screws from DVI I/F board.
4. Remove CN1 metal reinforcement from the connector, loosening two Hex screws.
5. Fix the CN1 metal reinforcement onto the replacement board, DVI I/F board.
6. Reverse steps 1 to 3.
Fig. 1 MU-231CR, Rear view
Program version
label
Fig. 4
Four M4 x 8
(24 other screws
are M4 x 10.)
CN14
CN16
Fig. 3 DVI I/F board
DVI I/F board
Fig. 2 MU-231CR, Cover removed
CN10
Two Hex screws
CN1 metal
reinforcement