Furuno FAR-2107 Series Service Manual page 216

EBL 1, 2 EBL ON/OFF
WATCH "Count-down"
HL OFF HL OFF
TX/STBY TX>STBY
GAIN
SEA AUTO>MANUAL
RAIN
TUNE AUTO>MANUAL
R/NM > L/L > NM/NM
CURSOR Data
(Range>L/L>X-Y-axis)
SET: 000.0 to 359.9 deg.
SET/ DRIFT
DRIFT:00.0 to 19.9 kt
Cont'd
When this turned on, the EBL bearing is
displayed.
Note:
In the setting [Menu] -> 2 -> 8, 9, the
relative and true bearing can be toggled
in the HD-UP and Cursor gyro modes.
The other presentation modes are true
bearing.
Count-down starts from the time set by
[Menu] -> 3 -> 4, and an alarm sounds
when "0" is reached. Place the cursor on
the [WATCH] box and click the left
button, and then the counting is reset.
Clicking the [ALARM ACK] box reset
the counting is also by.
Temporarily erases the heading line and
marks while pressed.
Toggling between STBY and TX, and
ending the ARPA test.
Adjusts the sensitivity of radar receiver.
Allows the adjustment of sea clutter in
the MANUAL mode, and it is saved.
Allows the adjustment of the rain clutter.
Allows the adjustment of tuning in the
MANUAL mode. A position of ▲
mark with respect to bar length shows
the tuned voltage value from 5 to 25 V
and the display on bar shows tuning
level.
Note:
[Menu] -> 1 -> 3
When the SET and DRIFT data is turned
off, the second cursor data is displayed.
On the IMO and A type radars, only one
cursor data is available.
When selecting R/NM, TTG is displayed
in the first cursor.
The SET/DRIFT is displayed when
SET/DRIFT setting in the [SPD] box
menu is turned ON.
When this is turned off, the second
cursor data is displayed except on the
IMO and A type radars.
Note:
[SPD] box menu -> 3
3-6
3.2 Box Menu