Mercedes-Benz GLC 200 4MATIC Owner's Manual page 232

Combo 2 vehicle socket
Press the centre rear section of socket flap
#
1 and swing the socket flap forwards and
open.
The % indicator lamp 3
display 4 light up white.
%
Socket flap 1 can also be opened via the
multimedia system .
When the vehicle is switched on (the õ
display is lit in the driver's display), socket flap
1 cannot be opened.
Press catch
#
cover 2.
%
The CCS charging cable connector requires
connections
essary to open both parts of socket cover 2.
Insert the CCS charging cable connector into
#
the vehicle socket to the stop.
Make sure that the charging cable is not taut
when inserted.
The # indicator lamp
display
high-voltage battery is charged, green.
%
When the charging sequence for the ambient
lighting is activated, the ambient lighting lights
up for approximately 30 seconds as with the
# indicator lamp
and upper status
When the charging cable is connected to the vehi-
cle, the vehicle cannot be started or moved.
At the start of the charging process, the charge
level display is shown in the driver's display with a
7 to the right and fold up socket
6 and 8. Therefore, it is nec-
5 and lower status
4 flash orange and, as soon as the
5 ( page 152).
/
Driving and parking 229
charging prediction. The charging prediction
refers to the time at which the high-voltage bat-
tery will be fully charged.
%
Depending on the temperature, the fan and
battery cooling system may audibly switch on
during the charging process.
%
If the vehicle is idle for lengthy periods and
connected to the mains supply, the high-volt-
age battery will be recharged automatically as
needed or when electrical consumers are
activated (e.g. the pre-entry climate control).
Ending the direct current charging process (mode
4)
Requirements:
The distance between the key and the vehicle
R
does not exceed 1 m.