Isolate Clients Of A User Wifi Network Without Exceptions - NETGEAR WAX220 User Manual

Essentials WiFi 6 AX4200 Dual Band Multi-Gig Access Point Model WAX220
A pop-up window displays.
9. Click the OK button.
Your settings are saved. The page closes. (The original page with the Wireless Settings
section and other sections remains open.)
Isolate clients of a user WiFi network without
exceptions
By default, client isolation is disabled for a user WiFi network, allowing communication
between the WiFi clients that are associated with the same user WiFi network. For
additional security, you can enable client isolation so that clients that are associated
with the same user WiFi network cannot communicate with each other. If you enable
client isolation, WiFi clients can still communicate with each other over the Internet.
Note: You can either enable client isolation without exceptions or client isolation with
exceptions (see Isolate clients of a user WiFi network and set exceptions on page 51).
To isolate clients of a user WiFi network:
1. Launch a web browser from a computer or tablet that is directly connected over WiFi
to the AP or connected to the same network as the AP.
2. Enter the IP address that is assigned to the AP.
If you are directly connected to the management WiFi network, you can enter
https://www.aplogin.net.
A login page displays.
If you do not know the IP address, see Find the IP address of the AP on page 24. For
more information about the management WiFi network, see Management WiFi
network on page 43.
If your browser displays a security warning, you can proceed, or add an exception
for the security warning. For more information, see kb.netgear.com/000062980.
3. Enter the AP login password and click the LOGIN button.
The AP login password is the one that you specified the first time you logged in to
the AP. The password is case-sensitive.
The Dashboard page displays.
4. Select Management > Network > Wireless.
The Wireless Settings page displays.
Manage Advanced WiFi Settings 50 User Manual