Table of Contents
Advertisement
5)
Press as to select [GROUP].
6)
Press qw to switch the item.
[A] - [Z]
7)
Press as to select [RESPONSE(ID GROUP)].
8)
Press qw to switch the item.
[ON]
[OFF]
Note
f When [INPUT SELECT] is set to [DIGITAL LINK], communication using that serial terminal is available only when the corresponding device
(such as the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G)) is connected to the <DIGITAL LINK>
terminal.
f When transferring logos via the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G), setting for "NO
SIGNAL SLEEP" of the DIGITAL LINK output supported device should be set to "OFF" to avoid interruption of communication.
f When [INPUT SELECT] is set to [DIGITAL LINK], communication speed for input is fixed to 9 600 bps and the parity is fixed to "NONE".
[REMOTE1 MODE]
Set the <REMOTE 1 IN> terminal.
1)
Press as to select [REMOTE1 MODE].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[DEFAULT]
[USER]
f Proceed to Step 3) when [USER] is selected.
3)
Press the <ENTER> button.
4)
Press as to select one from [PIN2] to [PIN8], and press qw to switch the setting.
[FUNCTION BUTTON]
Set the function of the <FUNCTION> button on the remote control.
1)
Press as to select [FUNCTION BUTTON].
2)
Press the <ENTER> button.
f The [FUNCTION BUTTON] screen is displayed.
3)
Press as to select a function.
[DISABLE]
[SUB MEMORY]
[SYSTEM SELECTOR]
[SYSTEM DAYLIGHT VIEW]
[FREEZE]
[WAVEFORM MONITOR]
[LENS MEMORY LOAD]
[ASPECT]
[PROJECTION METHOD]
[GEOMETRY]
4)
Press the <ENTER> button.
Chapter 4 Settings — [PROJECTOR SETUP] menu
Controls multiple projectors simultaneously by sending the ID of RS-232C. You can set groups from
[A] to [Z]. The projector responds when the ID of RS-232C matches the setting.
Returns the response when an ID is designated as GROUP.
Does not return the response when an ID is designated as GROUP.
Uses pin assignment of the <REMOTE 1 IN> terminal in standard setting. (x page 263)
Changes the setting of the <REMOTE 1 IN> terminal.
Disables the <FUNCTION> button.
Displays the sub memory list. (x page 160)
Switches the [SYSTEM SELECTOR] setting according to the input signal of the image being
projected.
f When the input signal is anything other than the SDI input
The [PICTURE] menu → [SYSTEM SELECTOR] (x page 92)
f When the input signal is the SDI input
The [DISPLAY OPTION] menu → [SDI IN] → [SYSTEM SELECTOR] (x page 114)
Switches the [SYSTEM DAYLIGHT VIEW] setting. (x page 88)
Freezes the image temporarily. (x page 123)
Displays the waveform of the input signal. (x page 123)
Loads the registered lens memory. (x page 126)
Switches the aspect ratio of the image. (x page 94)
Switches the [PROJECTION METHOD] setting. (x page 125)
Switches the [GEOMETRY] setting. (x page 96)
ENGLISH - 145
Advertisement
Table of Contents
