Table of Contents
Advertisement
7)
Press qw to switch to [ON].
8)
Press as to select [START] or [WIDTH].
9)
Press qw to adjust the starting position or correction width.
10) Press as to select [MARKER].
11) Press qw to switch to [ON].
f A marker for image position adjustment is displayed. The position where the red and green lines overlap for
the projectors to be joined will be the optimal point. Make sure to set the correction width for the projectors
to be joined with the same value. Optimal joining is not possible with projectors that have different
correction widths.
12) Press as to select [BLACK LEVEL ADJUST].
13) Press the <ENTER> button.
f The [BLACK LEVEL ADJUST] screen is displayed.
f By setting [AUTO TESTPATTERN] to [ON] on the [EDGE BLENDING] screen, the black test pattern is
displayed when you enter the [BLACK LEVEL ADJUST] screen.
14) Press as to select [NON-OVERLAPPED BLACK LEVEL].
15) Press the <ENTER> button.
f The adjustment area in the projected image becomes temporarily bright and the [NON-OVERLAPPED
BLACK LEVEL] screen is displayed.
f [RED], [GREEN], and [BLUE] can be adjusted individually if [INTERLOCKED] is set to [OFF].
16) Press as to select an item, and press qw to adjust the setting.
f Once the adjustment is completed, press the <MENU> button to return to the [BLACK LEVEL ADJUST]
screen.
17) Press as to select [UPPER WIDTH], [LOWER WIDTH], [LEFT WIDTH], or [RIGHT WIDTH] in [BLACK
BORDER AREA].
18) Press qw to set the standard width of [BLACK BORDER AREA].
19) Press as to select [UPPER FREE SHAPE], [LOWER FREE SHAPE], [LEFT FREE SHAPE], or [RIGHT
FREE SHAPE].
20) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
f Proceed to Step 28) when [OFF] is selected.
104 - ENGLISH
Chapter 4 Settings — [ADVANCED MENU] menu
The optimal point is the point at which these lines overlap.
Green line
Red line
Select this item when the shape of the border between [NON-OVERLAPPED BLACK LEVEL] and
[BLACK BORDER LEVEL] is not to be adjusted.
The region of the rectangle with the standard width set in Step 18) will be the [BLACK BORDER
AREA].
Select this item when the shape of the border between [NON-OVERLAPPED BLACK LEVEL] and
[BLACK BORDER LEVEL] is to be adjusted.
Advertisement
Table of Contents
