Table of Contents
Advertisement
9)
Press as to select [APPLY], and press the <ENTER> button.
f The confirmation screen is displayed.
10) Press qw to select [OK], and press the <ENTER> button.
Note
f When a button operation is performed on the device set to [DISABLE], the [CONTROL DEVICE PASSWORD] screen is displayed.
Enter the control device password.
f The [CONTROL DEVICE PASSWORD] screen will disappear when there is no operation for approx. 10 seconds.
f If the operations of both [CONTROL PANEL] and [REMOTE CONTROL] are set to [DISABLE], the projector cannot be turned off (cannot
enter standby).
f When the setting has completed, the menu screen will disappear. To operate continuously, press the <MENU> button to display the main
menu.
f Even when button operations on the remote control are disabled, the operation of the <ID SET> button on the remote control is enabled.
[CONTROL DEVICE PASSWORD CHANGE]
The control device password can be changed.
1)
Press as to select [CONTROL DEVICE PASSWORD CHANGE].
2)
Press the <ENTER> button.
f The [CONTROL DEVICE PASSWORD CHANGE] screen is displayed.
3)
Press asqw to select the text, and press the <ENTER> button to enter the text.
4)
Press asqw to select [OK], and press the <ENTER> button.
f To cancel, select [CANCEL].
Attention
f The initial password is "AAAA" by the factory default setting, or after initialized by one of the following methods.
g When initialized by selecting the [PROJECTOR SETUP] menu → [INITIALIZE] → [FACTORY RESET]
g When initialized by setting the [PROJECTOR SETUP] menu → [INITIALIZE] → [USER SETTINGS] → [OTHER USER SETTING] to
[INITIALIZE]
f Change the password periodically that is hard to guess.
f To initialize your password, consult your distributor.
Chapter 4 Settings — [SECURITY] menu
ENGLISH - 163
Advertisement
Table of Contents
