Table of Contents
Advertisement
Chapter 3 Basic Operations — Switching on/off the projector
How to remove the power cord
1)
Confirm that the <MAIN POWER> switch on the side of the projector is on the <OFF> side, and
remove the power plug from the outlet.
2)
Raise the power cord holder fixing the power cord upward. (Fig. 1)
f Fix the power cord holder by snapping into the projector.
3)
While holding the power cord connector, pull out the power cord from the <AC IN> terminal of the
projector. (Fig. 2)
Power indicator
Indicate the status of the power. Check the status of the power indicator <ON (G)/STANDBY (R)> before operating
the projector.
Indicator status
Off
Red
Green
Orange
Fig. 1
Power indicator <ON (G)/STANDBY (R)>
The main power is switched off.
The power is switched off. (standby mode)
Projection will start when the <POWER ON> button is pressed.
f The setting of the projector is as follows.
Lit
g The [PROJECTOR SETUP] menu → [QUICK STARTUP] is set to [OFF].
f The projector may not operate when the light source indicator <LIGHT> or the
temperature indicator <TEMP> is blinking. (x page 239)
The power is switched off. (standby mode)
Projection will start when the <POWER ON> button is pressed.
f The projector is in one of the following states.
g The [PROJECTOR SETUP] menu → [QUICK STARTUP] is set to [ON].
g When previewing the image corresponding to the input image to the projector
with the web control function. For details, refer to "[Remote preview lite] page"
(x page 186).
Blinking
f The indicator will change to a red light when the specified time has elapsed after the
projector enters the standby mode if the projector is set as following.
The specified time is the time set in the [PROJECTOR SETUP] menu → [QUICK
STARTUP] → [VALID PERIOD].
g The [PROJECTOR SETUP] menu → [QUICK STARTUP] is set to [ON].
f The projector may not operate when the light source indicator <LIGHT> or the
temperature indicator <TEMP> is blinking. (x page 239)
Lit
Projecting.
The projector is preparing to switch off the projector.
Lit
The power is switched off after a while. (Changes to the standby mode.)
Fig. 2
Projector status
ENGLISH - 55
Advertisement
Table of Contents
