Toyota 2H Repair Manual page 280

START I N G S Y S T E M -
P E R F O R M A N C E T E S T O F STARTER
CAUTI O N :
to seconds to a v o i d burning out the coil,
5
, . P E R F O R M P U L L - I N TEST
(a) D is c o n n e c t t h e f i e l d c o i l lead from t e r m i n a l C .
Ib) C o n n e c t the b a t t e r y to t h e m a g n e t i c s w i t c h a s
s h own. C h eck t h a t t h e p i n i o n g e a r moves
I f the pinion gear does n o t move, re p l a c e t h e m a g n e t i c
swi t c h assembly.
2 . P E R F O R M H O L D - I N TEST
While connected a s above w i t h t h e pinion gear o u t dis­
connecl t h e negative
the pinion g e a r r e m a i n s out.
t h e pinion
I f
switch assembly.
3 , I N S PECT P L U N G E R R E T U R N
Disconnect the n e g a t i v e 1- ) lead f r o m the s w i t c h body.
Check t h a i t h e pinion gear returns inward.
I f t h e pinion gear does n o t
switch assembly.
4 . PERFORM NO-LOAD P E R F O R M A N C E TEST
(a) Connect t h e b a t t e ry a n d ammeter to t h e s l a r t e r as
shown .
Ib )
C h eck t h a i t h e s t a r t e r r o t a t e s s m o o t h l y a n d steadily
w i t h t h e pinion gear m o v i n g o u t C h e c k that t h e
am meter r e a d s t h e s p e c i f i e d c u r r e n t .
S p e c i f i e d curre n t :
1 2 V T y p e
24V Type
S t arter
T h e se tests must be performed within 3
1-1
lead from terminal C . C h eck t h a i
gear re t u r n s inward, replace t h e magnetic
return, replace
1 80 A o r l e s s a t 1 1 V
90 A or less a t 23 V
ST - 1 9
o u tward.
the magnetic