Toyota 2H Repair Manual page 107

E N G I N E M E C H A N I C A L - C y l i nder Block
Number
Mark
(9)
lay a stnp of Plasligage across the crank pin.
(hi
Inslall the connecting rod c a p . (See
Torq u e : 900 kg-cm 165
NOTE: D o not turn t h e cra n k s haft.
{il
Remove the con necting rod cap
(j) Measure the Plastigage at ils widest point.
Standard oil clearance :
M a x i m u m oil c l e arance :
I f t h e clearance is greater t h a n m s )( i m u m , r e p l a c e the
If nec essary,
bearing.
N O T E : I f using a sta ndard bearing, replace with o n e hav­
ing the same number marked on t h e con necting rod cap.
There are two sizes of standard bearings, marked " 1" and
" 2 "
accordingly.
Standard bearing thickness {at center walll :
1
STD size 1 .480 - 1 .4 8 5 mm
10.0583 - 0.0585 i n . 1
STD size 2 1 .485 - 1 . 490 mm
10.0585 - 0.0587 In. 1
(k) C o m pletely remove the P lastigage.
1 4. REMOVE PISTO N A N D C O N N ECTING ROD
A S S E M B L I E S
( a ) Remove
all the carbon from
(b) Cover the con necting rod bolts. (See page EM-96l
(e)
P u s h t h e pis t o n . c o n necting rod assembly and upper
bearing out through the t a p of the cylinde r .
p
age E M - 1 1 6J
ft-Ib.
8 8 N ' m )
0.030 - 0.070 mm
10.00 1 2 - 0.0028 i n . 1
0 . 1 0 mm ( 0 , 0 0 3 9 i n . )
replace
grind or the crankshaf t .
the
pis to n r i n g ridge.
E M - 97