Toyota 2H Repair Manual page 83

E N G I N E M E C H A N I C A L
I N S T A L L A T I O N O F C Y L I N D E R HEAD [ 1 2 H -T]
(See page EM -48)
1 . I N S TALL C Y L I N D E R H E A D
l a ) Place a n e w cylinder h e a d g a s ke t on t h e cylinder
block.
C A U T I O N :
!b) Place t h e cy linder head on t h e cylinder head gasket.
Apply
(c)
under t h e c y l i nder h e a d b o l l s .
! d ) Install and uniformly tighten t h e
head bolts in several passes.
TorQ u e :
2 . I N S T A L L P U S H RODS
I n s t a l l the twelve p u s h rods.
3 . I N S TALL V A LV E R O C K E R S H A F T A S S E M B L Y
( a ) P l a c e t h e rocker s h a f t assembly on the cylinder head.
fbi Instal and uniformly tig hten the fourteen bolls in
several passes, in t h e s e q u e n c e shown.
Torque :
4. A D J U S T VALVE C L E A R A N C E
ISee steps 4 and 5 on p a g e E M - 2 2 1
Valve c l e a r a n c e ( R e ference) :
I n take
E )( ha u s t
C y l i n d e r Head
-
Be careful o f t h e installation direction.
l i g h t c o a l of e n g i ne o i l on t h e t h reads and
a
1 . 1 6 0 kg-em 183 f t - I b , 1 1 3 N ' m)
185 kg-em ( 1 3 f t - I b, 18 N ' m)
0 . 2 0 mm (0.008 in.)
0 . 3 6 mm (O.0 1 4
E M - 7 3
twenty-six
cylinder
t h e sequence shown.
1 0
in.)