Table of Contents
Advertisement
4 Installation procedures
Data terminal installation
To connect a data terminal to the M2000 Digital Telephone, perform the
steps in Procedure 2
Procedure 2 Data terminal installation
1
2
3
4
Task is complete.
The following figure shows the location of the RS-232-C and power
supply/converter connectors on the back of the M2000 digital
telephone:
Figure 2 Connection of the data terminal and MADO power supply
to M2000 digital telephone
555-4001-110 Standard 09.03 July, 2002
Connect the RS-232-C interface connector from the data
terminal to the matching header connector in the back of the
M2000 digital telephone. (See Figure 2.)
Insert the two captive screws in the connector body into the
threaded holes in the header connector, and secure tightly to
prevent accidental disconnection during data terminal operation.
Plug power supply/converter connector securely into power jack
that is to the right of the RS-232-C connector.
Plug power supply/transformer into the nearest AC outlet.
RS–232 interface
connector (25 pins)
Exit port for telephone
line and handset unit cord
5–pin power connector for
MADO power supply
Advertisement
Table of Contents
