Asr Procedures - Nortel M2000 Reference Manual

•
•
•
For a successful relocation, the new location must be equipped, and it
must be datafilled with the appropriate card type (NT8X47BA) in table
LNINV.

ASR procedures

To perform the ASR Out process, follow the steps in Procedure 8. To
perform the ASR In process, follow the steps in Procedure 9.
If the user forgets the personal identification code in Step 5 of
Procedure 6, operating company personnel may use the QUERY
Table DNROUTE must be datafilled to accommodate up to 160
specific ASR DNs that may be added to the table.
To enable a user to relocate a telephone set back into the system,
the system must create a temporary datafill allowing the user to
receive dial tone and dial the ASR In code. To accomplish this, the
system must have a directory number to use, as well as having a
customer group set aside for ASR In use, as follows:
— One DN must be set aside for ASR In use only. One DN must be
set aside for each set that is relocated at the same time as other
sets are relocated. Up to 1023 DNs may be relocated at the
same time. Therefore, up to 1023 DNs must be set aside for ASR
use.
— A special customer group must be identified for ASR In use only.
Enter this customer group in the system like any other customer
group. (This special ASR customer group is identified in table
OFCVAR for the entry ASR_CUSTGRP.) If customer group is
not identified for ASR_CUSTGRP, then no sets may perform the
ASR In or ASR Out process.
Note: It is recommended that this customer group be
established such that the user may only dial the ASR In code.
If the user is allowed to perform normal telephone functions
with the temporary datafill, there is no incentive for the user to
perform the ASR In process. If every user who performs the
ASR Out process decides not to bring the set back into service
by performing the ASR In process, the maximum number of
sets allowed in the ASR Out state would occur very quickly.
— The customer group identified in ASR_CUSTGRP is used for the
temporary datafill in table KSETLINE along with a SUBGRP of 0
and an NCOS of 0.
The ASR feature is assigned on a customer-group basis. Each
customer group is allowed to perform ASR must have an entry in
table CUSTHEAD identifying the ASR feature translator.
Meridian SL-100 M2000 Digital Telephone Reference Manual
Testing and maintenance 13