Nortel M2000 Reference Manual page 59

14 Testing and maintenance
command, ASRSHOW, based on the PDN of the set, to find the
identification number dialed by the user
.If an error is made during the code collection, the user may press the
asterisk (*) key to restart. However, if treatment has been given,
pressing the asterisk does not allow the user to reenter the digits for
that step. The user must hang up and try the ASR process again.
Displays associated with IVD sets are not used for any ASR processing
instructions.
Neither the ASR Out nor the ASR In process is available during an
image. If the user attempts to perform an ASR process, treatment is
given.
If a user performs the ASR Out process and afterwards realizes that it
was a mistake, only the Operating Company personnel can return the
LEN to service by accessing table ASRTABLE and deleting the entry
corresponding to the personal identification code entered by the user.
Next, the operating company personnel must access the LTP level of
the MAP workstation and BUSY the user's line before returning it to
service.
Procedure 8 ASR out process
1
2
3
4
555-4001-110 Standard 09.03 July, 2002
Take the set off-hook by pressing the PDN key.
Response: The system provides dial tone.
Dial the ASR Out code.
Response: The ASR Out code is datafilled in table IBNXLA. The
system provides special dial tone.
Note: Attempting to dial the ASR Out code on a secondary
DN of the set causes treatment to be given.
Dial the required ASR authorization code.
Response: The system provides special dial tone for successful
authorization or provides dial tone for the first invalid code. The
system gives treatment if a second invalid authorization code is
dialed.
Dial the required Personal Authorization Code.
Response: The system provides special dial tone for successful
authorization or provides dial tone for the first invalid code. The
system gives treatment if a second invalid authorization code is
dialed.