Table of Contents
Advertisement
The following restrictions and limitations apply to the MADO Self Test:
•
No calls can be made or received on either the voice line or the data
line of the M2000 Digital Telephone while the test is in progress.
•
The test can only initiate from the voice line of an M2000 Digital
Telephone equipped with MADO.
•
The test cannot initiate on a voice line that is currently engaged in
another feature.
•
MADO Self Test only tests the MADO within the M2000 Digital
Telephone that initiated the test.
The MADO Self Test may be unable to set up for the following reasons:
•
A feature data block could not be allocated.
•
The call is blocked in the network.
•
Another feature is already in progress on the line to be used for the
test. MADO Self Test cannot run on the third leg of a Conference 3
or Call Transfer call.
•
A maintenance process is running on the M2000 Digital Telephone.
•
The MADO line has not been datafilled.
•
The MADO Self Test was initiated from a telephone other than an
M2000 Digital Telephone.
Perform the following procedure to test the MADO. The access code to
activate the MADO Self Test feature must be datafilled in table
XLANAME and Table IBNXLA. Refer to sections "Table XLANAME" and
"Table IBNXLA" in this chapter for a description of applicable fields.
Procedure 4 MADO self test
1
Press a loop (DN) key.
Response: The system provides dial tone
2
Enter the MADO Self Test access code (usually two or three
digits as defined in table IBNXLA).
Response: The DN LCD flashes. MADO IS UNDER TEST
appears on the DTE screen.
If the LCD does not flash, MADO IS UNDER TEST does not
appear on the DTE screen, and reorder tone is received
continuously, the MADO Self Test could not be set up. Check to
ensure that the power source is properly connected. Replace the
handset, and try the MADO Self Test again at a later time. If
Meridian SL-100 M2000 Digital Telephone Reference Manual
Testing and maintenance 7
Advertisement
Table of Contents
