Switching Controller [1] And Controller [2] Displays - Samson TROVIS 6495-2 Mounting And Operating Instructions

Return to the operating level
4x Return to the operating level.
In the additional reading on the right
in the display, the Output AO2 is dis-
played numerically inverted.
7.1.3.3 Switching Controller
[1] and Controller [2]
displays
The left display is assigned to Controller [1]
and the right display to Controller [2] in the
default setting. Controller [1] is operated on
the left and Controller [2] on the right ac-
cordingly. If required, both controller dis-
plays can be switched around so that the left
display is for Controller [2] and the right dis-
play is for Controller [1].
Example: For cascade control (setting M.1-
3) the left display is assigned to the slave
controller and the right display is assigned to
the master controller. The displays are to be
switched so that the master controller (Con-
troller [2]) is shown in the left display ad the
slave controller (Controller [1]) is shown in
the right display. To do this, the submenu set-
tings A.2.1 Left display and A.2.2 Right
display must be changed.
EB 6495-2 EN
Start-up and configuration
Note
Before Controller [1] can be assigned to the
right display, it must first be removed from
the left display as one controller cannot be
assigned to both displays at the same time.
The controller is currently in the operating
level:
Î Enter the configuration menu (see sec-
tion 7.1.1).
Deactivate left display
6x Select A General settings menu.
1x Enter A General settings menu.
The A.1 Language / Sprache sub-
menu is highlighted.
7-15