Table of Contents
Advertisement
Maintenance Manual
Quarterly Maintenance Procedures
Models without Filter Condition Indicator:
Note: Models without a filter condition indicator
cannot be inspected. At the required maintenance
interval, replace the filters.
Hydraulic Tank Cap (if equipped):
1
Remove the breather cap from the hydraulic
tank.
2
Check for proper venting.
Result: Air passes through the breather cap.
Proceed to step 4.
Result: If air does not pass through the cap,
clean or replace the cap. Proceed to step 3.
Note: When checking for positive tank cap venting,
air should pass freely through the cap.
3
Using a mild solvent, carefully wash the cap
venting system. Dry using low pressure
compressed air. Repeat this procedure
beginning with step 2.
4
Install the breather cap onto the hydraulic
tank.
38
Q-11
Q-11 C heck the Ex haust System - En gine Mod els
Check the Exhaust System -
Engine Models
Genie specifications require that this procedure be
performed quarterly.
Maintaining the exhaust system is essential to
good engine performance and service life.
Operating the engine with a damaged or leaking
exhaust system can cause component damage
and unsafe operating conditions.
1
Be sure that all nuts and bolts are tight.
2
Inspect all welds for cracks.
3
Inspect for exhaust leaks; i.e., carbon buildup
around seams and joints.
Scissor Lifts
June 2022
Bodily injury hazard. Do not
inspect while the engine is
running. Remove the key to
secure from operation.
Burn hazard. Beware of hot
engine components. Contact
with hot engine components
may result in severe burns.
Part No. 1272215GT
Advertisement
Table of Contents
