Programmed Maintenance Procedures; P0-1 Inspect The Engine Air Filter - Gs-69 Rt - Terex Genie GS-2646 AV Maintenance Manual

June 2022
Pr ogr am m ed M ain te nan ce Pr o ced ur es
P0-1
P0-1 In spect the E ngine Air Filt er - GS- 69 R T
Inspect the Engine Air Filter - GS-
69 RT
Genie specifications require that this procedure be
performed every 40 hours or weekly, whichever
comes first.
Maintaining the engine air filter in good condition is
essential to good engine performance and service
life. Failure to perform this procedure can lead to
poor engine performance and component damage.
1 Kubota WG972 models: Remove the engine
tray flange nut, located under the radiator on
the engine pivot tray. Swing the engine pivot
tray out and away from the machine for
access.
2 Kubota D1105 models: Remove the wing nut
securing the end cap to the air cleaner
canister. Remove the end cap.
All other models: Disconnect the retaining
clamps securing the end cap to the air cleaner
canister. Remove the end cap.
3 Remove the air filter element.
4 Clean the inside of the air filter canister and
the canister gasket with a damp cloth.
5 Inspect for and remove any blockage or
debris from the intake air passages.
Part No. 1272215GT

Programmed Maintenance Procedures

6
7
8
Note: Be sure the dust discharge valve is facing
down when installed.
9
10 Kubota WG972 models: Swing the engine
Scissor Lifts
Inspect the air filter element. If needed, blow
from the inside out using low pressure dry
compressed air, or carefully tap out dust.
Securely install the filter element into the
canister.
Install the gasket and baffle (if equipped), and
end cap onto the air cleaner canister.
Secure the end cap to the air cleaner
cannister with the retaining clamps.
pivot tray back to its original position and
secure with the flange nut.
Maintenance Manual
61