Attaching The Set Pin And Magnetic Bracket; Attaching The Guide Rail - Lexmark Optra W810 Setup Manual

Attaching the set pin
and magnetic bracket
Note:
The set pin and magnetic
bracket form a connection between the
printer and the finisher. They are not
interchangeable with the set pin and
magnetic bracket for the 10-bin mailbox.
Rear view

Attaching the guide rail

1
Locate the screw holes on the
left side of the printer.
2
Attach the set pin and the mag-
netic bracket, as shown.
1
Slide the guide rail bracket
under the bottom of the
2500-sheet drawer, and lift the
bracket up until it clicks into
place.
The tabs of the guide rail bracket
fit flush against the side of the
2500-sheet drawer when the
bracket is properly installed.
Set up the optional finisher
103