Tcp/Ip - Lexmark Optra W810 Setup Manual

TCP/IP

Setting the IP address,
netmask, and gateway
Note:
Press
Menu>
see the correct menu item, and
then press .
Select
For instructions on other ways to set the IP address not documented
in the following sections, refer to the Drivers, MarkVision and Utilities
CD. Click
You must assign an IP address, netmask, and gateway to the
MarkNet print server for other network devices to find the printer on
the network.
•
•
Printer operator panel
You can use the printer operator panel to set the IP address, net-
mask, and gateway inside the print server. You must be standing at
the printer to use this method.
1
until you
2
3
4
View Documentation
If you have DHCP , the proper address values are automatically
assigned. To verify the assignment has happened, print a net-
work setup page and make sure the IP address, netmask, and
gateway appear as non-zero.
If you don't have DHCP , there are other methods you can use
to manually assign the address, such as the printer operator
panel, static ARP and telnet, RARP and telnet, BOOTP , or
MarkVision or another Lexmark utility. Instructions for three of
these methods follow.
Select ,
Network Menu
, .
IP Set IP Address
designates the network connector you are using for the print
X
server. For example,
Network Option 2
panel display if a MarkNet card is installed in network connec-
tor 2.
Use the menu buttons to set the IP address.
Press to advance to the next segment in the address.
Select
Press to increase the number by one. Press
Menu>
decrease the number by one.
Press Select until the word
Repeat steps 1 through 3 to
to .
Set IP Gateway
and then click
MarkNet Print Servers
,
Network Option X Network X Setup
appears on the operator
appears briefly.
SAVED
Set IP Netmask
Set up network addresses
.
,
TCP/
to
<Menu
, and then again
157