Adjusting The Side Door Tension - Lexmark Optra W810 Setup Manual

Note:
adjuster to its original position if you
remove the duplex option from the
printer.
70
Install the duplex option
Adjusting the side
door tension
Be sure to return the tension
9
Make sure the connector cords
are completely inside the
socket compartment.
10
Reinstall the connector cover.
If the connector cover is difficult to
reinstall, tuck the cords very
tightly inside the socket compart-
ment and try again.
After you install the duplex option, you
must adjust the tension of the wire that
supports the side door and the weight of
the newly attached duplex unit.
If you've already installed a 10-bin mail-
box or a finisher, you'll need to separate
it from your printer before following the
steps that begin on page 71.