Aligning the finisher
The finisher must be parallel with the
and the printer
printer and the two must be at the same
height, or you may have paper feeding
problems.
The following sections show how to
check for correct alignment, and explain
how to make adjustments, if necessary.
Adjusting the finisher's
Push the finisher up against the printer,
standing position
and then look at the two of them carefully
from the front.
If the finisher and printer resemble the
figure on the left, they are properly
aligned.
Skip to "Adjusting the finisher's height"
on page 116.
112
Set up the optional finisher