Grandstream Networks UCM630 Series User Manual page 198

Enable Route-Level Inbound
Inbound Mode
Inbound Mode Suffix
Inbound Multiple Mode
Dial Trunk
Privilege Level
Allowed DID Destination
Not using pattern-matching syntax means setting fix name to incoming caller.
Gives uses the ability to configure inbound mode per individual route. When
enabled two field will show allowing to set the Inbound mode and the Inbound
mode Suffix.
Note: Global inbound mode must be enabled before users can configure
route-level inbound mode
Choose the inbound mode for this route.
Note: Toggling the global inbound mode will not affect routes that have Route-
level Inbound Mode enabled. If all routes have the option enabled, toggling
the global inbound mode via BLF will trigger a voice prompt indicating that
none of the routes will be affected by the global inbound mode change.
Dial "Global Inbound Mode feature code + Inbound Mode Suffix" or a route's
assigned suffix to toggle the route's inbound mode.
The BLF subscribed to the inbound mode suffix can monitor the current
inbound mode.
Multiple mode allows user to switch between destinations of the inbound rule
by feature codes. Configure related feature codes as described in [Inbound
Route: Multiple Mode]. If this option is enabled, user can use feature code
to switch between different modes/destinations.
This option shows up only when "By DID" is selected. If enabled, the external
users dialing in to the trunk via this inbound route can dial outbound call using
the UCM's trunk.
This option shows up only when "By DID" is selected.

Disable: Only the selected Extensions or Extension Groups are
allowed to use this rule, when enabled Filter on Source Caller ID.

Internal: The lowest level required. All users are allowed to use this
rule, check this level might be risky for security purpose.

Local: User with Local level, National or International level are
allowed to use this rule.

National: Users with National or International Level are allowed to
use this rule.

International: The highest level required. Only users with
international level are allowed to use this rule.
This option shows up only when "By DID" is selected. This controls the
destination that can be reached by the external caller via the inbound route.
The DID destination are:

Extension
UCM630X Series User Manual
Version 1.0.2.25
P a g e | 198