Batteries - Fujitsu PRIMERGY CX400 M6 Upgrade And Maintenance Manual

▶ The circuit boards and soldered parts of internal options are exposed and
can be damaged by static electricity. To ensure reliable protection, you must
wear an earthing band on your wrist when working with this type of module
and connect it to an unpainted, conducting metal part of the server
enclosure.
▶ Do not touch the circuitry on boards or soldered parts. Hold the metallic
areas or the edges of the circuit boards.
▶ Install the screw removed during installation/detaching internal options in
former position. To use a screw of the different kind can cause a breakdown
of equipment.
▶ The procedure of installation on this notes might change depending on a
configuration of option.
3.2.4

Batteries

▶ Incorrect replacement of batteries may lead to a risk of explosion. The
batteries may only be replaced with identical batteries or with a type
recommended by the manufacturer.
▶ Do not throw batteries into the trash can.
Batteries must be disposed of in accordance with local regulations
concerning special waste.
▶ Ensure that you insert the battery the right way round.
▶ The battery used in this server enclosure may present a fire or chemical
burn hazard if mistreated. Do not disassemble, heat about 100 °C (212F), or
incinerate the battery.
▶ Replace the lithium battery on the system board in accordance with the
instructions in the corresponding upgrade and maintenance manual, chapter
"System board and components" > "CMOS battery".
CX400 M6 Upgrade and Maintenance Manual
Important information
29