Table of Contents
Advertisement
CAUTION
Installing procedures involving Upgrade and Repair Units must be
performed exclusively by Fujitsu service personnel or technicians
trained by Fujitsu. Please note that unauthorized interference with the
system will void the warranty and exempt the manufacturer from all
liability.
Preliminary steps
▶ Shut down the server nodes, see
▶
"Disconnecting the power cord" on page
▶ If applicable, remove the front bezel, see
page
48.
▶ Remove all HDD/SSD modules from the relevant HDD/SSD cage, see
"Removing a 2.5-inch HDD/SSD module" on page
▶ If applicable, remove all 2.5-inch HDD/SSD dummy module, see
a 2.5-inch HDD/SSD dummy module" on page
▶
"Removing server nodes from the server enclosure" on page
▶
"Removing the defective hot-plug PSU" on page
▶
"Extending the server enclosure out of the rack" on page
▶
"Removing the top covers" on page
▶
"Removing the defective high speed riser module" on page
▶ Remove all fan modules, see
▶
"Removing the fan cage" on page
▶
"Removing the power distribution board kit" on page
▶
"Removing the 2.5-inch HDD backplane" on page
CX400 M6
Hard disk drive (HDD) / solid state disk (SSD)
"Shutting down the server" on page
54.
"Removing the fan module" on page
120.
Upgrade and Maintenance Manual
42.
"Removing the front bezel" on
116.
113.
100.
49.
157.
122.
41.
"Removing
43.
151.
147.
131
Advertisement
Table of Contents
