Fujitsu PRIMERGY CX400 M6 Upgrade And Maintenance Manual page 153

Installing the new high speed riser module
Figure 116: Installing the high speed riser module
▶ Insert the high speed riser module between FAN1 and FAN2 and FAN4 and
FAN 5 as shown.
▶ Place the high speed riser module on the connector guide pin on the bridge
board and the guide pin on the power distribution board.
▶ Push the high speed riser module in the connectors without using the lever.
CX400 M6 Upgrade and Maintenance Manual
High speed riser module
153