Fujitsu PRIMERGY CX400 M6 Upgrade And Maintenance Manual page 113

Preliminary steps
▶ If applicable, remove the front bezel, see
page 48.
▶ Locate the correct drive bay, see
Removing a 2.5-inch HDD/SSD dummy module
Figure 78: Removing a 2.5-inch HDD/SSD dummy module
▶ Press both tabs together (1) and pull the dummy module out of its bay (2).
CAUTION
▶
Keep the dummy module for future use.
▶
Always replace dummy modules into unused HDD/SSD bays to
comply with applicable EMC regulations and satisfy cooling
requirements.
CX400 M6
Hard disk drive (HDD) / solid state disk (SSD)
"HDD/SSD bays assignment" on page
Upgrade and Maintenance Manual
"Removing the front bezel" on
108.
113