Fujitsu PRIMERGY CX400 M6 Upgrade And Maintenance Manual page 162

Power distribution board
Figure 126: Fastening the screws
▶ Fasten the power distribution board kit with four screws (see circle).
▶ Place the air duct on the power distribution board kit.
▶ Fasten the air duct with two screws.
Concluding steps
▶
"Installing the fan cage" on page
▶
"Installing the fan module" on page
▶
"Installing the new high speed riser module" on page 153
▶
"Installing the top covers" on page
▶
"Sliding the server enclosure into the rack" on page
▶ If applicable, install the front bezel, see
page 47.
▶
"Installing the new hot-plug PSU" on page
▶
"Installing server nodes in the server enclosure" on page
162
126.
148.
56.
"Installing the front bezel" on
Upgrade and Maintenance Manual
68.
101.
81.
CX400 M6