Table of Contents
Advertisement
Initial Setup
Use the following procedures to set up the TST-902 following installation.
Access the Setup Screens
The TST-902 may be monitored and configured using its local setup screens.
To access the setup screens after power is applied to TST-902 for the first time (or if no
l
user project has been loaded), tap the splash screen that is displayed.
After a user project has been loaded, access the setup screens by using the included t-pin
l
tool to press the reset button on the rear of the TST-902 four times within a five-second
period.
Set Up an Extended Range RF Connection
The TST-902 must be acquired to a Crestron Extended Range (ER) gateway, such as the
CEN-GWEXER
(not included), before it can be used with a Crestron control system.
For more information on creating an optimal wireless environment for the TST-902, including
where to position the ER gateway for minimal interference, refer to
Crestron RF Products Best
NOTE: Every TST-902 installation requires a Crestron ER wireless gateway to provide
essential wireless capability to the touch screen. The TST-902 will not work over Wi-Fi®
communications alone.
Product Manual — Doc. 7750C
Practices.
Installation and Setup of
TST-902 • 83
Advertisement
Table of Contents
