TST-902-DSW-BBI Installation
Use the following procedures to install the TST-902-DSW-BBI.
NOTE: The TST-902-DSW-BBI wall mount back box is a TST-902-DSW mounting accessory
that is designed for postconstruction applications where a back box will be installed into
masonry or concrete.
In the Box
Qty.
Description
1
TST-902-DSW-BBI, Wall Mount Back Box for TST-902-DSW
Additional Items
4
Screw, 6-32 x 1-1/2 in., Pan Head, Phillips (2007254)
Install the Back Box
To install the TST-902-DSW-BBI wall mount back box:
NOTES:
Depending on the installation, forced venting may be required.
l
The knockout holes are intended for Class 2 wiring and are 1-1/8 in. (29 mm) in
l
diameter.
1. Remove the appropriate knockout(s) on the TST-902-DSW-BBI for routing wiring to the
TST-902-DSW wall dock.
2. Route any wiring for the TST-902-DSW through the appropriate knockout(s) on the back
box.
3. Use the dimensions listed within
appropriately sized cutout in the mounting surface. No minimum clearances are required.
4. Mount the TST-902-DSW-BBI into the cutout in the mounting surface as shown in the
following illustration. Ensure the arrow on the label inside the back box is facing upward
prior to installation.
5. Install the TST-902-DSW wall dock into the TST-902-DSW-BBI as described in
58 • TST-902
TST-902-DSW-BBI Specifications on page 29
to create an
Install the
Product Manual — Doc. 7750C