Table of Contents
Advertisement
TST-902-DSW Installation
Use the following procedures to install the TST-902-DSW.
NOTE: The TST-902-DSW wall dock is designed for flush-mount installation in a flat, vertical
wall structure. Installation of the wall dock requires additional mounting hardware (not
included):
The
TST-902-DSW-BB
l
framed and masonry construction.
The TST-902-DSW-PMK, TST-902-DSW-WMKM, and
l
mounting kits are available for preconstruction and postconstruction applications that
do not require a back box.
In the Box
Qty.
Description
1
TST-902-DSW, Wall Dock for TST-902
Additional Items
1
Connector, 2-Pin (2003574)
4
Screw, 6-32 x 1-1/2 in., Flat Head, Phillips (2031703)
4
Plug, 0.35 x 0.50 in., Black (2042641)
4
Screw, 6-32 x 3/4 in., Pan Head, Phillips, Black (2007246)
1
Key, Release Lock (4522222)
Install the Mounting Hardware
One of the available TST-902-DSW mounting accessories (not included) must be installed prior
to installing the TST-902-DSW. Refer to the following installation procedures depending on the
chosen mounting hardware:
NOTE: Ensure the chosen mounting location allows for an air gap of at least 12 in. (305 mm)
in the wall cavity above and below the TST-902-DSW for heat dissipation.
For preconstruction applications where a back box will be fastened to the left or right-
l
hand stud of a framed wall prior to drywall installation, refer to
Installation on page
46 • TST-902
and TST-902-DSW-BBI back boxes are available for both
53.
TST-902-DSW-WMKT
TST-902-DSW-BB
Product Manual — Doc. 7750C
Advertisement
Table of Contents
