Table of Contents
Advertisement
For preconstruction applications where mounting hardware (without a back box) will be
l
fastened to the left or right-hand stud of a framed wall prior to drywall installation, refer
to
TST-902-DSW-PMK Installation on page
For postconstruction applications where a back box will be installed into masonry or
l
concrete, refer to
For postconstruction applications where mounting hardware will be installed in an existing
l
framed wall or similar flat surface using a mud ring, refer
Installation on page
For postconstruction applications where mounting hardware will be installed in an existing
l
framed wall or similar flat surface using a trim ring, refer to
Installation on page
Install the TST-902-DSW
The following procedure assumes that the a TST-902-DSW mounting accessory has been
installed completely as described in
preconstruction mounting hardware, it is also assumed that drywall is in place and a cutout for
the TST-902-DSW has been made.
To install the TST-902-DSW wall dock:
1. Route the wiring for the TST-902-DSW power connection through the rear of the
mounting hardware.
NOTE: The maximum wire size for the power connection is 18 AWG.
2. While holding the TST-902-DSW, connect the flying leads from the wiring to the 2-pin
power connector (24 G) on the rear of the TST-902-DSW.
3. Attach the TST-902-DSW to the mounting hardware using the four 6-32 x 1-1/2 in. screws.
The following illustration shows the TST-902-DSW being attached to the
TST-902-DSW-BB back box as an example.
NOTE: The cradle for the touch screen on the TST-902-DSW should be in the closed
position during installation.
Product Manual — Doc. 7750C
TST-902-DSW-BBI Installation on page
66.
76.
Install the Mounting Hardware on page
60.
58.
toTST-902-DSW-WMKM
TST-902-DSW-WMKT
46. For
TST-902 • 47
Advertisement
Table of Contents
