4. Adjust:
•
Skis
Adjustment steps:
•
Temporarily install the handlebar.
•
Hold the handlebar straight and check that the
skis are at right angles to the handlebar.
•
Loosen the locknuts (relay rod) 1.
•
Position the skis parallel in the riding direc-
tion.
•
With the skis in this position, turn the relay rod
2 in either direction until the handlebars at
right angles with respect to the direction of
movement.
Turning the relay rod
in direction a
Turning the relay rod
in direction b
SEJ3110
•
Tighten the locknuts (relay rod) 1.
Locknut (relay rod):
5. Install:
•
Handlebar
CAUTION:
•
Be sure the projection on the handlebar is not
SEJ3115
installed into the area a shown.
•
Be sure the side of the holder with the small
gap b faces forward.
•
Center the match mark c on the handlebar 1
between the handlebar holders (lower) 2.
Bolt (handlebar holder):
CAUTION:
SEJ3120
First tighten the bolts on the front side of the
handlebar holder, and then tighten the bolts
on the rear side.
SEJ3130
3-5
CHAS
STEERING
Turning the handlebar
in direction c
Turning the handlebar
in direction d
25 Nm (2.5 m • kg, 18 ft • lb)
®
LOCTITE
23 Nm (2.3 m • kg, 17 ft • lb)