Yamaha MM600D Service Manual page 210

1 Make sure a plastic band is
routed through the projection
located on the silencer, when
fastening it around the wire
harness, starter cable, throttle
cable and oil pump cable.
2 CDI unit
3 Make sure a plastic-locking tie
is routed through the
projection located on the
silencer, when fastening it
around the wire harness.
4 Connectors of the carburetor
switch
5 Water temperature sensor
coupler
6 Make sure a plastic band is
fastened around the wire
harness to prevent the coolant
reservoir hose from kinking.
7 CDI magneto couplers
8 Starter relay coupler
9 To the reservoir tank
0 Coolant reservoir hose
A CDI unit coupler
B Wire harness
C Make sure a plastic-locking tie
is routed through wire
harnesses as shown.
CABLE ROUTING
9-32
SPEC