Yamaha MM600D Service Manual page 24

COOLING SYSTEM
WARNING
To avoid severe injury or death:
•
Make sure the machine is securely supported
with a suitable stand.
•
Do not exceed 3,000 r/min. Drive line dam-
age and excessive V-belt wear could occur,
or the machine could unexpectedly move
forward if the clutch engages.
•
Operate the engine only in a well-ventilated
area.
•
Remove the coolant filler cap and bleed the
cooling system again, as described above.
No air bubbles → OK.
•
Add coolant to the specified level.
•
Pour coolant into the coolant reservoir 3
until the coolant level reaches the "FULL"
level mark.
SEJ2210
3. Install:
•
Bleed bolt cap
2-11
INSP
ADJ