Yamaha MM600D Service Manual page 198

CABLE ROUTING
1 Water temperature sensor
coupler
2 Fasten the carburetor switch
leads and the water
temperature sensor leads to
the coolant hose with a plastic
band.
3 Fasten the positive ignition coil
lead (cylinder #1) and the
negative ignition coil lead
(cylinder #3) to the starter cable
with a plastic clip. Position the
plastic clip at the connector of
the negative ignition coil lead
(cylinder #3).
4 Connectors of the carburetor
switch
5 Plugged with a coupler cap.
6 Fasten the coolant reservoir
hose and coolant hose with a
plastic clamp.
7 Ensure this is not kink.
8 Brake hose
9 Route the main switch wire
harness under the oil tank
breather hose and fuel tank
breather hose.
0 Install the main switch coupler
behind the instrument panel.
A Make sure that the main switch
wire harness is on the inside of
the instrument panel screw
(away from the engine).
B Route the parking brake cable
under the oil tank breather
hose.
C Oil pump cable
D Throttle cable
E Attach the clip to the wire end
(throttle lever side).
F Oil level switch
G Variable/resistor coupler
H Carburetor heating lever
I Speedometer cable
J Coolant hose
CABLE ROUTING
9-20
SPEC