Projecting; Selecting The Image Input For Projection - Panasonic PT-TMZ400 Operating Instructions Manual

Projecting

Check the connections of the external devices (x page 38) and connection of the power cord (x page 41)
and then power on the projector (x page 43) to start projecting. Select the image and adjust the state of the
image.

Selecting the image input for projection

Switch the image input for projection. Method to switch the input is as follows.
f Press the input selection buttons on the remote control and directly specify the input to project.
f Press the <INPUT SELECT> button on the control panel to display the input guide and select the input to be
projected.
Switching the input directly with the remote control
The input for projection can be switched by directly specifying it with the input selection button on the remote
control.
1) Press the input selection buttons (<HDMI 1>, <HDMI 2>, <COMPUTER 1/2>, <NETWORK/USB>).
Remote control buttons
<HDMI 1>
<HDMI 2>
<COMPUTER 1/2>
<NETWORK/USB>
f When switching inputs, the input guide for detailed or simple display is temporarily displayed. For the input
guide, refer to "Switching the input with the control panel" (x page 50) or the [DISPLAY OPTION] menu
→ [ON-SCREEN DISPLAY] → [INPUT GUIDE].
Attention
f Images may not be projected properly depending on the external device, or the Blu-ray disc or DVD disc, to be played back. Set the
following menu items according to the input signal.
g [PICTURE] menu → [RGB/YC
g [PICTURE] menu → [RGB/YP
g [PICTURE] menu → [RGB-SYSTEM]
f Confirm the aspect ratio of the projection screen and the image, and switch to an optimum aspect ratio from the [POSITION] menu →
[ASPECT].
Chapter 3 Basic Operations - Projecting
Remote Control
Input
HDMI 1
HDMI 2
COMPUTER 1
COMPUTER 2
MEMORY VIEWER
NETWORK
C ]
B R
P ]
B R
Control Panel
Switches the input to HDMI 1.
Displays the image signals input via the <HDMI IN 1> terminal.
Switches the input to HDMI 2.
Displays the image signals input via the <HDMI IN 2> terminal.
Switches the input to COMPUTER 1 or COMPUTER 2.
Displays the image signals input via the <COMPUTER 1 IN> terminal
or the <COMPUTER 2 IN> terminal.
If one input has been selected already, the input will be switched
every time the button is pressed.
Switches the input to MEMORY VIEWER or NETWORK.
If one input has been selected already, the input will be switched
every time the button is pressed.
f MEMORY VIEWER: Displays the still images in the USB memory
with the Memory Viewer function. (x page 107)
f NETWORK: Displays images transmitted from a terminal over
wireless LAN / wired LAN by using the image transfer application
software. (x page 109)
Usage
ENGLISH - 49