Panasonic PT-TMZ400 Operating Instructions Manual page 29

r Connecting terminals
1 <SERIAL IN> terminal
This is the RS-232C compatible terminal to externally control the
projector by connecting a computer.
2 <LAN> terminal
This is the LAN terminal to connect to the network.
This also supports the image transfer from the image transfer
application software.(x page 110)
3 <COMPUTER 1 IN> terminal
This is the terminal to input RGB signals or YC
4 <USB (VIEWER/WIRELESS/DC OUT)> terminal
When using the Memory Viewer function, attach the USB
memory directly to this terminal. (x page 107)
Attach the wireless module (Model No.: AJ-WM50) directly to this
terminal when using the wireless LAN function. (x page 111)
In addition, this terminal can be used for power supply (DC 5 V,
maximum 2 A).
Attention
f When the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [NORMAL], the <USB (VIEWER/
WIRELESS/DC OUT)> terminal can supply power even in standby state. If set to [ECO], the <USB (VIEWER/WIRELESS/DC OUT)>
terminal can not supply power in standby state.
f When an external device exceeding the rating (DC 5 V, maximum 2 A) is connected to the <USB (VIEWER/WIRELESS/DC OUT)> terminal,
an error is detected and the power supply will be stopped. At this time, disconnect the external device, cut off the power of the projector and
then reconnect the power plug to the outlet.
f When a LAN cable is directly connected to the projector, the network connection must be made indoors.
The signal may deteriorate due to the effect of noise or cable length.
Chapter 1 Preparation - About your projector
1 2 3
7
C /YP P signals.
B R B R
4 5
8
5 <AUDIO OUT> terminal
This is the terminal to output the input audio signal.
6 <HDMI IN 1> terminal / <HDMI IN 2> terminal
These are the terminals to input HDMI signal.
7 <COMPUTER 2 IN> terminal
This is the terminal to input RGB signals or YC
8 <AUDIO IN 1> terminal / <AUDIO IN 2> terminal
These are the terminals to input audio signals.
6
C /YP P
B R B R
ENGLISH - 29
signals.