Panasonic PT-TMZ400 Operating Instructions Manual page 150

Basic format (has subcommands)
Sub command (5 bytes)
*1 When transmitting a command which does not need a parameter, an operation (E) and parameter are not necessary.
Attention
f If a command is transmitted after the light source starts illuminating, there may be a delay in response or the command may not be
executed. Try sending or receiving any command after 60 seconds.
f When transmitting multiple commands, be sure to wait until 0.5 seconds has elapsed after receiving the response from the projector before
sending the next command. When transmitting a command which does not need a parameter, a colon (:) is not necessary.
Note
f If a command cannot be executed, the "ER401" response is sent from the projector to the computer.
f If an invalid parameter is sent, the "ER402" response is sent from the projector to the computer.
f ID transmission in RS-232C supports ZZ (ALL) and 01 to 64.
f If a command is sent with a specified ID, a response will be sent to the computer only in the following cases.
g It matches the projector ID
g When [PROJECTOR ID] (x page 83) on the projector is [ALL]
f STX and ETX are character codes. STX shown in hexadecimal is 02, and ETX shown in hexadecimal is 03.
Cable specification
Control command
The following table lists the commands that can be used to control the projector using a computer.
r Projector control command
Command Details
PON Power on
POF Power standby
150 - ENGLISH
Chapter 7 Appendix - Technical information
Parameter (6 bytes)
Symbol "+" or "-" (1 byte) and setting or adjustment value (5
bytes)
Operation (1 byte)
*1
"=" (Set the value specified using parameter)
When connected to a computer
1
2
3
Projector
4
(<SERIAL IN> terminal)
5
6
7
8
9
Parameter/response
string
―
Same as the basic format
*1
NC NC 1
2
3
Computer
NC NC 4
(DTE specifications)
5
NC NC 6
7
8
NC NC 9
Remark (parameter)
To check if the power is on, use the "Power query" command.