Panasonic PT-TMZ400 Operating Instructions Manual page 48

f Projection of the image will stop, and the power indicator <ON(G)/STANDBY(R)> on the projector lights
orange. (The fans keep running.)
3) Wait until the power indicator <ON(G)/STANDBY(R)> on the projector lights or blinks red.
f The projector enters standby mode when the power indicator <ON(G)/STANDBY(R)> lights or blinks red.
4) Disconnect the plug of the power cord from the outlet.
Note
f For approximately five seconds after the projector is turned off, the indicator does not light up even if the power is turned on.
f Even if the power is turned off by pressing the power <v/b> button, the projector consumes power if the power plug is connected
to the outlet.
When the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO], use of some functions is
restricted, but the power consumption during standby can be conserved.
f The projector supports direct power off function. You can cut off the power supply during projection by disconnecting the power cord from
the outlet or by switching off the circuit breaker in case of ceiling mount. However, the settings or adjustments performed right before the
power is turned off may not be reflected.
48 - ENGLISH
Chapter 3 Basic Operations - Switching on/off the projector