Replacement - Panasonic PT-TMZ400 Operating Instructions Manual

Table of Contents

f Do not disassemble the air filter unit.

Note

f Replace the air filter unit with a new optional Replacement Filter Unit (Model No.: ET-RFL400) if it is damaged or if the dirt does not come off

even after washing

Attaching the air filter unit

Attach the air filter unit to the projector.

f Hold the air filter unit with the tab on the left side as shown in the figure, attach it from the right side, and

push the tab until it clicks.

f Do not press on the crease part of the air filter when pressing into place.

Attach the air filter cover to the projector.

f Perform in the reverse order of the Step 2) of "Removing the air filter unit" (x page 137) to close the air

filter cover. Make sure to press the air filter cover firmly until it clicks into place.

f When the air filter unit is attached to the projector, proceed to the "Resetting the air filter counter" (x page 138).

Note

f When using the projector, be sure to attach the air filter unit. If it is not attached, the projector will suck in dirt and dust causing a malfunction.

Resetting the air filter counter

Turn on the projector.

Press the <MENU> button on the remote control or the control panel.

f The main menu screen is displayed.

Press as to select [PROJECTOR SETUP].

Press the <ENTER> button.

f The [PROJECTOR SETUP] screen is displayed.

Press as to select [FILTER COUNTER].

Press the <ENTER> button.

f The [FILTER COUNTER] screen is displayed.

Press as to select [FILTER COUNTER RESET] and press the <ENTER> button.

When the confirmation screen is displayed, press qw to select [OK], then press the <ENTER> button.

f The [PROJECTOR SETUP] menu → [FILTER COUNTER] → [FILTER COUNTER] is displayed as "0H".

Note

f When the projector is used without resetting the filter counter, the actual filter usage time (counter numeric value) will not be able to be confirmed.